Machine Specification ~

• This machine uses two Rolls of Cold Seal Material to make the protective pouch.
  
• The lower web of the material runs over the infeed table and carries the product into the sealing portion.
  
• This is where the Upper Roll of material joins the product to form the protective pouch.
  
• The end seals and length cutoff are done simultaneously in the sealing head of the system.
  
• The machine uses pre set length counters to regulate the package size.
  
• Machine operation and setup are done thru the touch screen controller.
  
• This allows the operator to make adjustments quickly and easily.
  
• The system is available in 18" and 36" Wide Models
  
• The maximum Width and Height thru the machine varies upon Model
  
• The 600-18 has a 5" High Package Capability
  
• While the 600-36 has an 8" High Package Capability
  
• Length thru the system is only limited by what can be supported on the Infeed Table
  
• Most all cold seal materials can be run on the model 600, these include:
  
  • Corrugated
  • Polyethylene
  • Kraft Papers
  • Foams
  • Bubble
    
• The Standard System has a 5' Infeed Table and a 3' Exit Conveyor
  
• It uses 230/460 V.A.C. and 80 PSI
  
• It has a Single roll stand mounted prior to the Infeed Table and one above the sealing head
  
• It also has a touch Screen controller with a built in Batch Counter
  
• The units can run packages up to 35 packages per minute